Vipergear ICP and axis
-
Hi,
I’m using Vipergear ICP and I would like to use BRT/CONT to adjust CRS and HDG.
I set it in axies but it does it 5° by 5°, can we change that ?
Thanks
-
See BMS-Technical-Manual page 162: section titled g_nKnobAccelerationDelta
-
See BMS-Technical-Manual page 162: section titled g_nKnobAccelerationDelta
Hi
thanks for your reply
I putted g_nKnobAccelerationDelta 0 in falconbms.cfg
but same
-
I’m not sure you understood the options explained in that manual.
You need to put set g_nKnobAccelerationDelta 0 if you want to turn off acceleration.
Then use the By1 callback versions of SimHsiCourseInc and SimHsiCourseDec (i.e.: SimHsiCrsIncBy1 and SimHsiCrsDecBy1). Do the same for SimHsiHeading.
See BMS Keystrokes - Defaults.pdf page 9 in your \Falcon BMS 4.34\Docs\01 Input Devices folder.
By default you will get By1 increments if you turn the dial slowly and By5 when you turn the dial faster. Have you tried just turning the dial more slowly when you get near the number you want to set?
-
I use ICP rotaries with avionics control, not good ?
thanks
-
As we can see here
doing just step by step from my encoder
there’s a problem Kunsan !