Help getting Warthog Stick to work with Siatek X56 throttle and rudder pedals
-
Hi all,
Apologies if this has already been covered but there are a LOT of forum posts on HOTAS setup to read through even after using the search. Please point me to the relevant page if it has been covered.
I have a Warthog stick, a Saitek X56 throttle and Saitek rudders. I can get either the Warthog to work or the Throttle & Rudders but not all 3 at once. I’ve updated the device sorting file to have the Warthog stick at the top but still no joy. Also in Setup, if I set the AB/Idle point then switch away from the throttle to the Warthog, it forgets the setting even after clicking apply and OK.
This particular combination of devices gives me the best set up for my particular work/play area so any help to get them working together would be very much appreciated.
Thanks,
-
I think you are misunderstanding. You do not switch away. You set one controller as your primary and assign the axis mappings in the advanced controller setup.
So if you have your Warthog stick in the Setup UI and set in advanced the throttle axis to your Saitek and apply the Idle lines they will get assigned to your SaitekGesendet von meinem SM-G930F mit Tapatalk