And that’s good, thanks to it

Whether the BMS does not support scaling to full screen. If I switch the game resolution in the UI settings to a different resolution than the TV monitor resolution, the game is reduced to the image in the upper left corner of the monitor, only reducing the display resolution to the resolution set in the game extends the image to the entire screen. Setting up scaling to full screen in the Nvidia tab does nothing. In previous BMS versions this worked as usual
If anyone can advise anything, I listen

OK .

Please help me on how to display the 2d user interface in the center of the monitor.
In addition, if in the graphics settings I use a resolution lower than in my monitor, then when entering 3d the image also does not display full screen, as if scaling did not work

However, it succeeded, but on LHD, it’s probably not possible. And this is not the maximum weight.

Wait a minute and I’ll make a video , Maximum permissible weight

Stevie, you don’t understand me. The point is to start with the permissible mass at all. Not vertically, but from the short LHD run down, as Flow showed.

Don’t screw me in, I tried this maneuver. Even if it’s full speed, it will fall after using this nozzle trick. As if you were writing, I would have started vertically.

From what I tested, in BMS 4.34 Harrier is only suitable for land airports, because starting with a weapon from the short LHD Wasp on peno is not possible. With great luck it can be done with the CV-71.

Well, in BMS 4.33 harrier could start with a catapult, and here it doesn’t work. And in the Carrier Ops manual it says that the harrier is full-function for operations from an aircraft carrier, just like the f-18 hornet