@itsbobbaayy Tried the the Block 50 Tonight as well. Same issue as the 40 block.
Latest posts made by itsbobbaayy
-
RE: TD box in DTOS
-
RE: TD box in DTOS
@airtex2019 @airtex2019 This also affects all bomb release modes not just DTOS. So I spent all my trial runs in the 40 block. The hud sensor works fine after take off as long as I don’t touch anything else in regards to sensors. It seems to me most of the time the issue will arise if I use the fcr/tgp and setup a markpoint or target target track. Bore sighting mavs will also start this issue. I’ve tried only having the same type bomb on board to see if there was weapon interference but it still happens. Then when I switch to a/g it will sometimes make the hud SOI properly or completely blocks it. I’ve tried cancelling any cursor slews across all modes. Changing back to the STP where it was initially working doesn’t help once the error occurs. Turning off power to all other available sensors or running STBY whilst blanking out all OSBs across all modes doesn’t help. Switching to MRM/Dogfight and back. It sometimes will fix itself and allow Hud SOI on its own with no input on my end. I’ve done every combination of FCR/TGP modes/ OSB combinations on NAV/AG/AA master modes. I have also used TMS commands to break tracks as well as any other TMS combo just for trial and error in combination with the aforementioned.
-
RE: TD box in DTOS
I have a similar issue. When trying to use DTOS mainly it won’t allow my HUD to be the SOI. Sometimes it will sometimes it won’t. I’ve been messing with it for hours trying to fix it in flight. It will DMS up and remove SOI from MFD but won’t actually goto the HUD. The asterisk will flicker for a split second. Then randomly down the road it will allow the HUD to be SOI. I’ve even turned off all the other sensors and it still won’t allow the HUD to become the SOI.