@jfeagin
that did it! now it works perfectly!
thank you and all the users who shared their suggestions!
regards
Rubberduck85
@jfeagin
that did it! now it works perfectly!
thank you and all the users who shared their suggestions!
regards
Rubberduck85
@jfeagin
Thanks,
i have the F-16 grip.
Those DX1 and DX31 are read while i move the throttle but they do not stick in the button assignment.
I was reading about an XLS config file. Can i assign them from there?
Regards
Rubberduck85
Hi and thank you. So is it necessary to set it as 4x32 in the SimApPro? What does it do?
I understand the i need to map the “buttons” correlated to a specific throttle position but they aren’t read. Is this linked to the 1x128 vs 4x32?
Also where can I find the excel version? It would help immensely in quick rebinding if needed.
Regards
Rubberduck85
@Badger i tried also there but no success.
Hi,
i’m trying to get my Winwing Orion 2 Throttle to work 1:1 with the in-cockpit Throttle.
It works fine in the range Idle to Gate.
However i tried to have it shut down the engine by moving it to the off position (behind the “IDLE” detent) but i’m unsuccessfull.
I tried with the very nice tool ALT LAUNCHER by @chihirobelmo
1st odd thing is that it is detected as a Thrustmaster Warthog (which is not)
2nd i cannot assign the IDLE by pressing button “IDLE Detent” if the throttle is phisically positioned behind the “IDLE” detent.
I also tried with the CFG application:
but no changes.
Am I doing something wrong?
Is there a work-around
is it a BMS-ORION compatibility issue?
Thanks for any help.
Regards
Rubberduck85