4.35U1 Stick stuck
-
Hey guys once again I’ve reloaded4.35 and set-up my controls when I find out. my stick is not moving. I had this problem and I had seen a post on how to get it moving, but unfortunately did not mark the page to come back to. Ant one have an Idea on how to fix it?
Rhino
-
You’ve reviewed the axis assignments, in the Setup / Controllers / Advanced pages? They show movement on the 2D setup screen … but not in flight?
-
First make sure your stick has been selected in the “Controller” selection box, under SETUP > CONTROLLERS
Next, click on the “ADVANCED” button and select the “FLIGHT CONTROL” tab (tab just to the left of the circled tab pictured below) - verify that you see movement and that the axes are properly assigned as you need for your controller:
-
Hey guys once again I’ve reloaded4.35 and set-up my controls when I find out. my stick is not moving. I had this problem and I had seen a post on how to get it moving, but unfortunately did not mark the page to come back to. Ant one have an Idea on how to fix it?
Rhino
Set the device which has the pitch and bank axes on it using the drop down menu. Don’t change it. The feedback section which shows motion may not be correct. Don’t panic! Go into the advanced section and set all the appropriate axes. When you have made all the settings in advanced section then the feedback area should work as expected.