Hey guys once again I’ve reloaded4.35 and set-up my controls when I find out. my stick is not moving. I had this problem and I had seen a post on how to get it moving, but unfortunately did not mark the page to come back to. Ant one have an Idea on how to fix it?
Rhino
Icer, I also found this website
(http://www.driven-technologies.com/) don’t know if you have seen it but they are made to fit. Check it out.
Rhino
Thanks for the info Icer. Much appreciated.
Rhino
Hi everyone, I’m looking for the monitors that fit Thrustmaster mfds. I’m building a cockpit and I’m not sure where or what to buy. Any help would be appreciated.
Thanks, Rhino
Hey jc1, Have you seen this before (include “target.tmh”) whereas target.tmh is in Red? At the very start of the profile. There are other instances of this throughout the profile, just in a few places. This problem is just not with the S3 version, but also with the jc1 profile. Also, the joystick will not move in x or y in the UI. For some reason, this has happened overnight. Any thoughts.
Rhino
Yes, I saw that you had added that one so the Coolie switch is back working with Waypoints? Cool, I was just using the rocker which was Ok also but, that’s even better. Hey, there have been a lot of changes since 4.33 and 4.34. Do you have to be on the right frequency for things like tower, tanker, wingman things like that? I was out doing a refresher fly on #11 or something and when I bring up the menu their blank? What’s up with that I figure radio.
Thank again for the work, Rhino
Hey jc1, I made all the changes the other day and everything is working just right. As far as waypoints go I’m just using the rocker switch. It’s not a problem at all. Thanks for taking the time to put together the script. It makes everything so much better for me as you know I have always used the S3 switch. Short fingers I guess.
Thank you again, Rhino
Thank you, Malc
Rhino
Hey Malc, Thanks again worked perfectly and so easy. I was going through Microsoft office 365 for an hour and still couldn’t find anything. This was too easy,
Rhino
Hey everyone, I got a quick question what word processor do you use to put numbers on the line of a page. What I’m doing is following up on making some changes to a TMC file but when I open a file I have no line numbers. and I need that so I don’t have to count. Any ideas?
Thanks, Rhino