Solved 4.37 RTT Issue
-
If you haven’t uninstalled 4.36 you should have it.
-
@benco said in 4.37 RTT Issue:
If you haven’t uninstalled 4.36 you should have it.
I have not deleted it yet. I looked into the 4.36 RTT folder but the content looks the same as 4.37. I was hoping to find something like an easy setup or something
Regards.
-
You can set size in the
RTTClient.ini
file. I use the following values to display them on my second monitor:MFDLEFT_X = 40 MFDLEFT_Y = 1080 MFDLEFT_W = 650 MFDLEFT_H = 650 MFDRIGHT_X = 1205 MFDRIGHT_Y = 1080 MFDRIGHT_W = 650 MFDRIGHT_H = 650
By setting width and height manually for both MFDs, you can guarantee that they are the same size. They are square, so make sure height = width for both of them.
-
use this handy little app to position your extracted windows
https://forum.falcon-bms.com/topic/19489 -
-
@Tumbler31 several threads report that RTTConfig stopped working, in 4.36 … but I don’t know what possibly changed, to break it.
-
@airtex2019 still works ok here. But note it looks for/sets the .ini file in the .35 folder. So just make this path exists and it should work fine
-
@Tumbler31 said in 4.37 RTT Issue:
@airtex2019 still works ok here. But note it looks for/sets the .ini file in the .35 folder. So just make this path exists and it should work fine
Great thanks for the heads up! I ended up creating a registry key for Falcon BMS 4.35 and pointed it at 4.37 - worked great
-
This post is deleted! -
This post is deleted! -
This post is deleted! -
See my post. I believe you need to create a Falcon BMS 4.35 registry entry - looks like a relative path is added to the value added there. By pointing it to 4.37, there is no need to sync the ‘RTTConfig.ini’ file.
I suspect @Tumbler31 already had this entry?
-
This post is deleted!