Tusba Cougar throttle cannot be calibrated in Win11
-
And this is what I get in BMS UI. This is in full AB:
-
@Doc0301 can you send a RS screen with throthle at minimun?
-
This is what i will make
Unninstal tusba in device panel
Restart Pc (tusba auto recognized)
Pair axes, moving all to Max and minimun.See if the throthle axis moves all their routes (full Green and full grey)
-
Another important thing, unmark the vertical Green bar (right mouse Burton i think) to disconnect the three throthle axes, to use all the throthle as an axis.
At this moment there is no way to use three axes (idle, min and aft) in bms, only one Axis.
-
This is with throttle at minimum:
And this is at maximum:
-
@Doc0301 Try calibrating in Windows instead of RS tool.
-
Unninstal device in Devices
Restart
PairI make that and works for me.
-
@Skorp I think it’s one of the last thing to do and perhaps fresh install of BMS can resolve something.
If it doesn’t work, back on win10
-
Dont go uninstalling anything until you have removed RS from the equation, and as @Icarus said, check if your device is showing up as a HID device in windows, and try calibrate it there.
-
Yes, bms is not the problem.
-
Problem solved !!
Windows callibration made that the full range was recognized again !! Then pairing TUSBA & Throttle and set calibration in RS HID Device tool. Then deleted the old TUSBA controller files of the Alternate Launcher so that new files could be made with a new callibration.
Now everything works perfect!
You guys have NO idea how gratefull I am to this community for helping me out . It’s a gratifying experience in this day and age that totally strangers are willing to sacrifice their time to solve your problem. You guys rock! And BMS forever !!!
Tiger! Tiger! Tiger!