Solved RTT Export problem after U3
-
Hello,
I have a “weird” problem after the U3 update, with the RTT Export for external MFDs.
My right MFD works as normal, but my left MFD, is not exported with the correct width and height, I tried changing it (in the RTT .ini file) both up and down, but it doesn’t change at all. The upper left corner is in the correct position…
It works as normal for the right one when changed width and height.
Best regards
-
@Guard_85 MDF?
(typo’s)
-
You have to redo the .cfg file. I usually back mine up and copy and paste it over. You may have to walk it around a little bit to get it to fit. I run separate monitors for the RTT extract for MFDS. To see any changes to the position you have to save the file and then restart RTT.
-
@Jumpstart5179 yeah, have separate monitors as well, right one works like a charm, left one does not. What do you mean with redo the .cfg file?
In user cfg RTT export is set to 1, and the settings in the .ini for RTT is identical for left / right MFD, except for the screen coordinates (which is correct)…
-
@Guard_85 the .ini is what I was referring too. It sounds like you X and Y are off. It happens to me after every major update
-
In the bms config file;
set g_bExportRTTTextures 1
set g_nRTTExportBatchSize 2and the RTT . ini file is like this:
USE_MFDLEFT = 1
USE_MFDRIGHT = 1MFDLEFT_X = 2642
MFDLEFT_Y = 9
MDFLEFT_W = 620
MDFLEFT_H = 620
MDFLEFT_ONTOP = 1MFDRIGHT_X = 3416
MFDRIGHT_Y = 9
MFDRIGHT_W = 620
MFDRIGHT_H = 620
MFDRIGHT_ONTOP = 1This gives me MFDs on the two monitors I have for the external MFDs, and the right one is good, with the correct size (620x620), but the left one is not showing as 620x620, rather 300x300, and it doesnt change no matter what I set in the .ini file. (the coordinate for the upper left corner is correct, and was changed when edited in the .ini file).
-
@Guard_85 MDF?
(typo’s)
-
@Guard_85 Is it showing on the right screen?
-
-
@airtex2019 Damn! Guess it is the eyes you go blind on first!