Warthog and cms
-
Hi all, in the middle of the training sessions and cms on my warthog stick doesnt work anymore, it works on keymapping and shows in setup but doesn’t work in flight any ideas, its been fine for weeks and now just wont work, have I pressed or mapped something wrong?
Amy help would be appreciated.
-
@AllenB1971 so many possibilities hard to say … need more info
did you power on ecm systems and set modes appropriately? maybe zoom in and post a screen snip
did you recently create a new callsign and it wiped your ecm programs? again a small screen snip would help
did you maybe inadvertently select a wrong/different key file? if you post your key file to https://pastebin I’ll take a look
-
@airtex2019 hi airtex2019 will get theses to you as soon as I can, thanks
-
@airtex2019 strange as they all work on key mapping and setup but not in cockpit; plus thinking about it they’re all set up in the training missions aren’t they?.
-
@AllenB1971 As I mentioned in the PM, first confirm if the physical switch is working and has not just gone kaput on you. Test in Windows or in other games. If the switch is working, then go back to an older training mission where it used to work. Is it still working there?
Chances are the new training mission where it doesn’t work is because you were supposed to set up your CMDS panel or some other setting which you have not done, hence why there is no response from the CMS switch. Maybe the old training mission was an air start with the aircraft fully configured and the new training mission starts from a cold-and-dark.