MFD/TGP
-
Hi All,
How can the TGP is zooming and reset ?
Thank you!
-
Hi All,
How can the TGP is zooming and reset ?
Thank you!
Go to the DOCS folder in your BMS install and find the:
TO BMS1-F16CM-34-1-1
Go to chapter:
1.9 SNIPER XR ADVANCED TARGETING POD
And read it:
1.9.3.3 Variable Zoom
The Sniper provides electronic zoom control that can be changed from 1x to 4x using the MAN RANGE/UNCAGE knob
on the HOTAS. The variable zoom stays the same between sensor changes and the variable zoom setting label
appears below the FOV label under OSB 3.While you’re at it, go and read the rest of the manual(s).
-
Zoom is done with axis assigned to TGP zoom/radar gain knob. Also there is narrow and wide FOV for thermal, you can switch with pinky or how it was called.
When you say reset i guess you mean CZ (cursor zero). You do it by doing TMS AFT first (to get to slave mode) and then pressing CZ mnemonics on TGP (or FCR or HSD) page. It is important to do TMS AFT to go back to slave mode, otherwise pressing CZ will do nothing. -
Default keys: V toggles narrow and wide, ALT+F3 and ALT+F4 (this does not quit BMS, don’t worry) zooms in and out. TGP must be SOI.