Falcon 4.33 and 4.34 will not load any reolution other than default
-
I built a new system recently for VR and loaded up Falcon 4.33 and 4.34 on it. System specs: i9 9900K, ASUS RoG Strix 2080Ti OC, 64GB G.Skill Trident-z 3200, ASUS Z390 E Gamer board, Samsung Evo 970 Pro 1TB drive, Samsung 49" Wide screen monitor @ stock res of 3840x1080 and Dell 23" Touch Panel for Helios/YAME.
I bought the monitor first and when hooked up to my other system which is an i7 7700K with 1080Ti BMS loaded right into 3840x1028 at 120Hz and looked gorgeous. It would not run at 144Hz though. However since I’ve installed on the new system which runs VR without breaking a sweat BMS will not load into the 3D world except for in the default low res. When I exit out of the Instant Action BMS locks and goes to the Million Soft screen. I have to Cntl/alt/delete to kill and sometimes it jacks up the monitors to where I can’t even do that.Then I have to hard reset…… Any ideas?Thanks!
-
Disable full screen optimisation in the .exe properties
-
Thank you sir… It’s been a long time since I’ve done a complete dance… lol All good.