Axis for Comm1 and Comm2 not switching comms on
-
Bound 2 axis to Comm1 and 2 when switching to UHF preset and Switching to Both then turning the axis should switch on the comms but doesnt, the axis works as i can see them turning, scrolling with mouse wheel then instantly turns comms on. Any idea why its doing this? 4.35
-
there’s a button at the early course of the axis. That button must be used as COM 1 ON/OFF & COM2 ON/OFF
Turning the axis changes the volume but without the button don’t power the radio -
@Red:
there’s a button at the early course of the axis. That button must be used as COM 1 ON/OFF & COM2 ON/OFF
Turning the axis changes the volume but without the button don’t power the radioThanks will assign those.