Have to reset/calibrate all my axisses and knobs whenever I go out of pit
-
Like the title says: everytime I get out of pit I have to reset everything
[EDIT] After rebooting voor de xth time, I suddenly only have to reset AB and Idle and some deadzones in UI
-
@Doc0301 FAQ.
The Alt Launcher (the new default launcher) overrides everything.
You have to either (A) setup and maintain your axes and bindings in the new launcher.
Or (B) bypass the new launcher or check the “don’t apply overrides” checkbox before launching BMS. If you want to use a key file you maintain yourself.
-
The problem is that the new launcher missed the AB/Idle setting for the throttle and also the possibility to revert joystick axes or add dead zone.
So, using the new launcher I need to reset the AB/Idle position everytime… -
-
@airtex2019 not the throttle.
I have a full pit and some radio axes are reversed and also I need to add sone dead zone to my rudder pedals… -
Sorry, my mistake.
I found everything. -
-
@airtex2019 said in Have to reset/calibrate all my axisses and knobs whenever I go out of pit:
No. Throttle axes are normal, but everytime before I can go in pit, I have to do the following :
- set AB and Idle positions
- set the deadzone for my rudder
- set the deadzones for both X- and Y-microcursor.
- Reset both axes for my microcursor (they have been switched )
- X-axis for X-microcursor has to be checked “reversed”
-
@Doc0301 do you use the launcher?
Are you resetting all this stuff in sim and not in the launcher?
Any changes you make in-sim will not be saved if you use the launcher, as the launcher overwrites the key file with its own one on every launch.
-
@SOBO-87 In UI. I understand, but after a lot of trouble getting my BMS working on my new PC and Win11 (A LOT of trouble!) I 'm glad I got it working at all. Was just wondering if there was a way to avoid this little dance without FUBAR my setup
-
@Doc0301 ok so you don’t use the launcher at all?
-
@Doc0301 if things are still borken with 4.37.1 + Alt Launcher 2.3 … can you post a screenshot of your AXISASSIGN page?
I’m assuming you’re using the new/alt launcher… wasn’t clear.
-
@SOBO-87 That’s just it! I set all my keybinds with the Alt, but BMS didn’t find my TUSBA throttle axis. After a week of searching it suddenly worked and now I’m afraid of changing anything. Did I mention I’m a computer zero
-
@Doc0301 when you said BMS didn’t find your TUSBA axis? Did it show up in the launcher? But didn’t work in sim?
-
@SOBO-87 BMS did see my TUSBA throttle , but I only had 40% of the full range. FYI It works fine now. The problem described above remains, but I can live with it
-
@Doc0301 have you tried resetting the things you reset in the launcher rather than in sim UI?