Slew Cursor Delay
-
hat buttons or axis???…if axis, like my ch hotas, try adding a deadzone.
X/Y axis. Deadzone in TARGET or in BMS UI? I have tried in BMS all the settings and deadzone helps a little bit but not enough to make it work satisfactory.
-
That is not my experience with the WH slew, mine will stop immediately on release. I use Morphine’s profile, perhaps give that a try if not already.
Also try another sim (DCS perhaps) to see if it is the same behavior in that sim. If you do not have DCS, DCS World and the Su-25T are free. So no cost but time to give it a try.
The problem is that it is present without running any profile at all, so I don’t think his profile will make a difference, but I will give it a try. I have tried all the profiles included with TARGET and all of them have this problem.
Edit: I tried Morphine’s profile and it is way worse. It is like the cursor is moving through molasses.
-
If someone can post the event time(ms) in device analyzer of the time it takes for the slew cursor to go from zero to max then return to zero that would really help me out. Also, if someone can go into their game controllers properties and test the throttle slew cursor axis and see if it has a delay when releasing it, that would be helpful. Just hold the slew curser at max then let go and see if it has a delay. Thanks.
-
After much testing I have found that it doesn’t matter the curve or sensitivity. It is lag. So if the curve is slow it is very noticeable. If the curve is fast it is not as noticeable. I am torn between sending it back as a hardware problem or trying to figure out what software problem could be doing this. I did buy it at a good discount so I wonder if it is a unit that has been sent back a few times.
-
Sorry Viking, I’m away from my PC for a bit so can’t check for you. I will look when I get back. Hopefully you have it solved before then.
-
Are you still running that CPU @ 4.4GHz
-
-
First on my list if having input problems would be reset back to standard clocks.
4.4 is not a mild OC.
-
First on my list if having input problems would be reset back to standard clocks.
4.4 is not a mild OC.
I finally got a hold of TM tech support and they say it is a hardware problem and gave me several choices. Either have them send me a new slew, with instructions on how to get to the switch but not on how to change it. It could be glued in there, so I passed on that. Or, send it to TM in Canada to have them fix it, or send it back to newegg for a replacement. I think I am going to try newegg first then go with Canada if new egg takes too long or is not efficient.
-
Sounds like a plan……good luck.