Default viewpoint with TIR
-
Hi,
I would like to know if it’s possible to change “center” viewpoint of TIR in BMS ?
I explain : with no TIR, just hit Pan Pit key twice and the default view shows MFDs
With TIR, I always have to look down to see MFD, I would like the default view to be as before.
I wouldn’t like to look up, press F12 tweak to have this view
Thanks a lot
-
You can shift the vertical axis, shift it from Zero to + …
-
where ?
thanks
-
You should have for your actual profile in the left part a part named “Curve”…
Beside that there a two green arrows.
With these arrows you can shift the Zero point of the vertical axis.
Up means: “You are sitting higher”
Down means: “You are sitting deeper”
(Or vice versa, how ever you take it…)HTH
-
Yes it works it change the angle but when I rehit F12 key it’s not the good position
I really would like to change the default angle when I hit center TIR
thanks