I have updated my nvidia drivers as of yesterday. I run my game in window/borderless mode as well. I use a clean config in 4.35. I have removed RTT and had 1 successful flight as of now. Looks promising without RTT.
remove the RRT?
I have updated my nvidia drivers as of yesterday. I run my game in window/borderless mode as well. I use a clean config in 4.35. I have removed RTT and had 1 successful flight as of now. Looks promising without RTT.
remove the RRT?
seems that running in windowed mode has put a temporary stop to the crashing… don’t know why it won’t run in full mode?
All i could upload was a screen capture of the dump file … the forum wouldn’t accept the actual file as an attachment…sorry, hope this will help?
Hi,
Been unable to play through a single flight since installnig 4.35.
Completely fresh clean install as per instructions. Is their a way to verify file integrity at all or just reinstall?Most recent crash was when switching on HMD but have been various different causes so far.
Same thing happens with me…. i7 processor, 16 gig ram, nvidia 1080ti vid, 3 AoC screens … any solutions?, im stumped
Just thinking out loud:
What stick/throttle do you have. Maybe someone around has the same setup.
You are clicking Apply before exiting the Setup screen?..
Make sure devicesorting in your config folder is set to read-only.
Other than these I’m not sure why it wouldn’t be saving your choices
yep….config folder to read only…good call…thank you!
when I setup my joystick, throttle and pedals in the controls box and leave my joystick selected and then launch the sim only my joystick will work and not my throttle…but if I go back into setup and leave my throttle chosen in the controller box then launch the sim, only my throttle will work and not the joystick…any idea what I’m am doing wrong?.. any help would be greatly appreciated
Thanks for the help Darkman and Yassy….much appreciated
no appdata folder shows up under my user name….but when i try to create an appdata folder, it says it is already there???..any help would be appreciated?
I tried unplugging everything except my Saitek keyboard and the command pad continues to take the id1 slot and the joystick id2 and throttle id3……should i try changing to a stock keyboard…or is there a way to change the script to look for id2 and id3?
I use win 7 64……I will try unplugging my pedals and see if that does the trick…thank you very much
No matter what I do, my TM controller ID’s always look like the attached in my DirectX Diagnostic Tool?
……and why does my controller show up as " Thrustmaster Virtual Game Controller (root)" in the DirectX Diagnostic Tool after i run .TMC file with the TARGET Script editor…am I missing a step here?