@VIPER-0 Thanks for your advise Viper.
Best posts made by Louis 0
-
RE: Any pilot programmed x52 pro with Joy2Key and made it work for falcon bms?bms flight control
-
RE: AA radar cursor problem: can not get it back.
Thanks Lorik. I looked up your videos. They are interesting, good work. I think the solution is (I found in a 2020 pubs) to step through the next target in time with msl step sw. Cheers.
-
X52pro DX button profile via Keymapping.
Hello Pilots! I made direct DX binding using Alt Launcher Keymapping as seen in the attachment. Is there a way to make an other profile? I understand that shifted layers can not be done in this way. I tried to make an other profile when loaded in BMS UI the BMS-Basic instead of BMS-Full. I L-clicked Full and properties and checked to Read Only and unchecked the same in Basic before loading it. However I could not make an other different profile. Both keyfiles after loading had the same button responses. Help would be appreciated if more experienced pilot has got an idea and share it with me.
-
New player can get into air in 2 hours.
It might be good for new players who find the first steps in BMS rather difficult. Make a copy of BMB-Full keyfile, select and load it in BMS-UI Controllers page, type e.g. Shift Home, highlight it, hit the desired button (or move the slider to the desired direction) on your controller and you have TMS UP on your button. This button mapping useful for Taxy-Landing-NAV-Dogfight-AIM9-120 and good for limited use in AG bombing. . Make sure the Full-Copy is not wright protected and when finished the mapping hit apply in UI, check that the Keyfile-Copy has all bindings written in (BMS-User-Config and double click Keyfile-Copy, read at the bottom what you mapped). Finally right click Keyfile-Copy-Properties and check (write protected) to prevent overwriting. The keyboard is Hungarian (check on Google).
Depending on your controller’s button number you have to use the keyboard to a certain extent. However, you do have to know that in this way you can not have shifted layers and for shifted layers you have to use a different Keyfile and DX binding or some other programming methode (like SST programming).
N.B. orbit cam is to make sure that you lowered the gear before landing and pinkie button brings back the previous HUD used just as DF cancel brings back the previous (NAV, AA or AG),
Enjoy!