Trying to get my cougat hotas recognised by my W10 PC
-
try to remove all Cougar entries in the usb listing using this tool https://www.nirsoft.net/utils/usb_devices_view.html.
hope it helps
-
Badger and Redneck,
I first removed all my cougar listings as suggested by redneck. After that I installed using Badger’s link. I selected the windows 8 compatibility mode in the properties.
But to no avail. I keep getting the E2 failure after starting the CCP. I also followed the troubleshoot page. But it keeps saying the cougar is connected. (In USBdeview it shows as connected)
Verzonden vanaf mijn iPad met Tapatalk
-
Did you do a reset,
Disconnect the usb
Hold the trigger and plugin the usb while trigger pressed for a sec or ~5. -
Redneck, Badger,
after fiddling around I was able to try everything over again. and I was able to connect to CCP. So I managed to finish with the VIPERGEAR manual. So, I think I m good now.
cheers
-
Good to know you got it sorted.
Any idea what did the trick? -
Way too o stick with it.
-
Good to know you got it sorted.
Any idea what did the trick?I think the TUSBA was preventing detection. After I disconnected and did everything again it started to go uphill from there. The only thing now is that if I put my values (using CCP) at 320-330) I get good response for the roll. But not for the Pitch control. I can pull stick but I cannot bring the nose down.
any suggestions?
-
I keep getting this error message:
-
The manual says put it to auto cakibration, put it to manual calibration.
I know i need to update the manual but i simpley to busy to get the new icp done. -
The manual says put it to auto cakibration, put it to manual calibration.
I know i need to update the manual but i simpley to busy to get the new icp done.Redneck,
I just send you an email (sales@……)
Windmill
-
Got it and replied.