[Released] EMF v1.0.5 (BMS 4.35)
-
any solution problem?? still same
edit problem solved.:);)
but my mfd extractor dont show screens in EMF map why??
-
any solution problem?? still same
edit problem solved.:);)
but my mfd extractor dont show screens in EMF map why??
Welcome to the club an egg search in the forum will answer your question
Στάλθηκε από το MI 5 μου χρησιμοποιώντας Tapatalk
-
How come I don’t see anything on the map I uploaded with mission commander?
I mean airports, factories, ports, etc. etc.
-
Just a quick guessing, it will take quite some time to retrieve all these, since it is a huge and high-res map.
-
Ouch! My download manager shows the estimated dl time 12 hours! Normally downloading a file of this size takes no longer than 20 minutes on my internet connection; about 5 minutes via torrent… What gives?
-
How come I don’t see anything on the map I uploaded with mission commander?
I mean airports, factories, ports, etc. etc.
Just a quick guessing, it will take quite some time to retrieve all these, since it is a huge and high-res map.
The Save0-5 are empty basically as there no working campaigns ATM as far as i understand at least
-
I am still transfering two of my campaigns from EMF1.04 to EMF1.05.
A lot of work to do.
sledgehammer and Rat Patrol
-
hi, I tried all the saves from 0 to 5 and when I load them the map is empty
-
Ηi,
Read 1st post.
-
Hi M_J,
I managed to build a campaign for my own use using the SAVE0.cam that works perfectly either single or multiplayer conditions. Then I tried to build a second one with a different scenario using cam files 1 to 5.Every time the second campaign starts only if it is saved as scenario: save0 and saved name: save1 to save5 depending which cam file I used with MC. But even when started the second campaign merges the two “scenarios” frag missions for both senarios and messages from both campaign senarios pop up as news concerning countries that are not active in the second campaign a fact that seems partially logical. When I save the cam as scenario:save1 to 5 and saved name:save1 to 5 campaign doesn’t start. Are cam files 1-5 corrupted or I have to study more? In BMS 434 I managed to build 4 campaigns without problems. Thanks in advance.
All the best,
John -
Can you share the SAVE0.cam you prepared?
-
The most recommendable:
-
-
This post is deleted! -
Can you share the SAVE0.cam you prepared?
Sorry m8. As I said it is for my own use and I have not such permissions.
-
Is there any limitations about proposing new campaigns/mods for this theater?
-
-
Campaign works fine on the EMF1.05. I have made an initial test of my campaign " Rat Patrol"
Another campaign " Sledgehammer" involved Greece and Turkey is still being transferred from EMF1.04 to EMF1.05.
-
Joker duke how to contact you are you on discord?
-