Flt panel bit test
-
Hi all, after some time i have started again with Falcon.
So i see that a lot of things are changed, it’s fantastic, i have only a doubt, i don’t understand why during ramp start, my bit fail every time, even if i use the switch more time.
Thanks -
Use the “Reset” switch before the BIT
-
@Maverick996 You have to clear any FLCS faults by using the “RESET” switch. As well make sure you don’t touch the rudder or stick during the process. Other than that there is a random fail coded as well but the probabilities are low IIRC.
-
Thanks all guys i will try soon
-
@Maverick996 said in Flt panel bit test:
Thanks all guys i will try soon
You’re right the problem was That.
Thanks again