ILS
-
Is there a switch to turn the Ils on and the TR and AA tacan
-
Page 64 in the T.O. BMS1-F16CM-34-1-1 (located in the docs folder of your BMS install)
1.3.5. T-ILS page (1)
This page refers to the TACAN and ILS settings. You can access it through the T-ILS ICP button.
The first line of the DED gives the TCN and ILS status (ILS is
turned on/off with the ILS knob on the AUDIO2 panel).
The scratchpad is on the left between the two asterisks and that is
where the TACAN & ILS frequencies are entered. The system is
able to differentiate a valid TACAN channel (0-126) from a valid ILS
freq (VHF 4 or 5 digits). The next line gives the current and active TACAN and ILS frequencies
respectively and the last line displays the TACAN band (X or Y) and the CRS set for the ILS approach.
To enter a new TACAN channel or an ILS frequency simply input the relevant numbers within the
asterisks and hit ENTR.
To change the TACAN band: input 0 (zero) in the scratchpad and press ENTR. That toggles from X to
Y to X and so on.
To change the TACAN from T/R (ground domain) to A/A TR (air domain) use the DCS SEQ button.
ILS CMD STRG can be inhibited or activated by placing the scratchpad over it and mode selecting it
with the M-SEL 0 ICP pushbutton. The CMD STRG line in the DED is highlighted when command
steering is active.
To change the ILS course place the scratchpad on the CRS field using DCS up/down and enter the
correct runway heading for the active ILS. Press ENTR to input the data into the system.Verstuurd vanaf mijn F5121 met Tapatalk
-
ILS switch is on Audio 2 panel
“TR and AA tacan” not sure what you are asking ???
-
ILS switch is on Audio 2 panel
“TR and AA tacan” not sure what you are asking ???
Switched on the ILS page of the ICP.
-
Is there a switch to turn the Ils on and the TR and AA tacan
Well about this, means to change between TR and AA state the TACAN, refer to “Terminator” reply from the specific doc:
“To change the TACAN from T/R (ground domain) to A/A TR (air domain) use the DCS SEQ button.”
So click the DCS SEQ button to its right position.
Nikos. -
Thank you Just What I needed
Again Thanks for the help
-
Switched on the ILS page of the ICP.
The ILS indicator is on the DED the ILS switch is on the Audio 2 panel
-
The ILS indicator is on the DED the ILS switch is on the Audio 2 panel
A/A v T/R is switched on the ILS ICP page …. that’s what I was referring to.
-
Agave_Blue - you are correct it is.
Looks like we were both correct on the two halves of his question - that’s nice “you can be my wing man any time” … ho no here we go again !!! and they are going to remake it !!!