RWS mode soft-lock two targets: Unable to soft-lock the 2nd target
-
Goodday,
I am trying to softlock two targets by using the RWS mode.
I move my cursor over the first target and TMS -UP once and lock it. However i am unable to move the cursor to the 2nd target.
It is as if the cursor is glued on the target i’ve locked initially.
There are times where i where i do manage to soft lock the 2nd target.
However most of the time i am unable to move the cursor when first target is softlocked.To move the radar cursor i am using the mini stick on the saitek x52 throttle.
I have also used the keyboard to move the radar cursor toward the 2nd target most of the time without any succes.
GSos,
-
Yeah …. the first one is ‘sticky’, but if you keep pushing/nudging the cursor, it should ‘un-stick’. I’ve never quite found a trick or secret to get it to release, just keep trying to ‘force’ the cursor until it does.
-
Your cursor speed is set too low. You aren’t generating enough input to override the snap.
-
TWS, not RWS right?
-
No …. RWS / TTT (Two Target Tracking).
-
Section 1.12.1.1 of the -34 highlights RWS two target SAM
-