How to use 3 monitors
-
Hi folks,
I have 3 identical monitors attached to a Nvidia GTX 1060 videocard. I’d like to use the 3 monitors asa widesccreen. Using the surround mode of the nvidia only the center monitor displays,
What can I do. Appreciate any help.THX
Orbi -
_Hello !!
Look at this Thread
https://www.benchmarksims.org/forum/showthread.php?10302-Possible-3-monitor-config
Get a look here!
https://www.benchmarksims.org/forum/…een-resolutionto calc the dez to hex, get a look here
http://www.langeneggers.ch/nuetzlich…html?Wert=2560get a hex editor here
http://www.chip.de/downloads/Hex-Edi…_30351843.htmlI hope you can solve it !!!
Good flights !!!_ -
What I do is leave the displays separate, extended desktop, and set BMS to windowed. In my case I didn’t have the desired resolution available in BMS until I set eyefinity to 5760x1080. After selecting the resolution I was able to retain that resolution after returning to separate non-eyefinity display configuration unless I changed something in setup (annoyingly).
-
Hi folks,
I have 3 identical monitors attached to a Nvidia GTX 1060 videocard. I’d like to use the 3 monitors asa widesccreen. Using the surround mode of the nvidia only the center monitor displays,
What can I do. Appreciate any help.THX
OrbiDid you go into the pit or just stay at the menu?
Have the same setup with 4 monitors and 3 are set to surround at 5910x1080, the menu/map only displays on the center monitor, but once you go to fly, it should fill all 3 monitors if you have the resolution set correctly. -
open nvidia settings.
go to Configure Surround Physx
Enable Span displays with Surround
press configure. -> Might give you an alert to end some apps. like trackir app. kill them from task manager then press ok.
make arrange selection
3x1 or 1x3 sorry not on the pc now.
apply.
You might need to go to windows display settings, or nvidia settings and move arround the 1 2 3 monitors to the correct position.
ready go fly. -
I run three 19" 1280x1024 monitors with a Nvidia 1080. I just used “Configured Surround” in the Nvidia Control Panel to setup Eyeinfinity and set the resolution (3840x1024) in config screen in BMS. When BMS is in the menu it is single screen and when in 3D mode it goes to all three screens. I don’t run windowed mode. In my Falcon BMS.cfg I have FOV set as set g_fDefaultFOV 120
I haven’t had to do this, but I’ve seen in google (http://16thaccw.com/BBS/viewtopic.php?t=2188) that someone put set g_bAllowAllRefreshRates 1 in their FALCON BMS.CFG to see all resolutions available (page 162 of the BMS-Technical-Manual.pdf).
-
Thommo either you have nvidia surround or amd eyfinity
-
Hi Arty,
after different attemps it finally works. Unfortunately the picture is a bit distorted. May with some fine tuning e.g. different F.O.V. settings in configuration this could be fixed.
Actually I will make use of a 4th monitor to display the Front Instrument Panel.THX to you and all other for your support. Great Community!
SiX!