Voice control
-
Wow,you guys are so over my head,i feel like a idiot ( of which i am ) but appreciate all the help.
Anyhoo,so i went in my key file and replaced the deselect key to sim do nothing and added the 1 instead of 0 in the config file .
Started foxvox , went in the library,cleared the ptt assigned then reassigned the ptt with the comm 1 down.
Sure enough,the same two keys showed up .
So i simply clicked on the key i dont want and deleted it .
Now when i started bms i went in my settings,loaded my file and now where it used to say deselect,its simply says bms full which is my profile
But flew a mission and it worked better than i expected, no problems,had to repeat words once in awhile but still learning .
Anyhoo, tinker time. -
@oldtommyboy what you observed makes sense. The key file content is not involved in the business of FoxVox seeing two buttons pressed from your DX devices β that comes from the device hardware and Windows DX device driver. If you canβt change the behavior of the device, via programming software for it, to make it not show use always on buttons for some physical switch throws then I think you are stuck with your workaround or using the ignore list that @foxster put into the FoxVox program for this kind of situation.
-
@Boxer thx, u know i always wondered why whenever i start bms and go to setup,select my key file,load and always noticed that dgft/msm deselect was shown .
Now it just loads and showing bms full, my file name.
So it has always shown as activated,never really thought about it till using foxvox.
So now its still activated i guess even though nothing to activate.
Confused on why that particular key , something still not quite right in my key file, no clue.
Anyhoo, thankyou
Till my next WTF !!!