Face track noir, with delan clip setup..

[mastersetter]

Hi, how can i increase the sensitivity of this tracking setup? All is working fine, but i have to move my head too far in order to say, look over the pilots shoulder etc, i need more on screen movement for less physical movement. Tried various settings in and out of bms, but nothing is really making much difference. Is it the FOV settings or curves i should be focusing on?

Thanks for any help

[hoover]

Check the “Axes” tab in FTNoIR, you can increase the sensitivity of the axis movements separately and in whatever manner imaginable to man.

Uwe

[cns180784]

Mastersetter i too have just received my Delan clip and am about to set it up with FTNOIR, did the solution hoover suggest solve the sensitivity issue? also- i have received my Delan Clip but without daylight filters, will it still be ok? and what can i use as an alternative, would photo negatives do the trick?

[JLSPENCER02]

@cns180784:

Mastersetter i too have just received my Delan clip and am about to set it up with FTNOIR, did the solution hoover suggest solve the sensitivity issue? also- i have received my Delan Clip but without daylight filters, will it still be ok? and what can i use as an alternative, would photo negatives do the trick?

Exposed photo film is good but if you have a old computer 3.5 floppy disk media works great too.

[mastersetter]

cns, i think the floppy disk is prob the easiet way to go. I found that i had to alter the curves in the software, to get the movement where i wanted it. I will post a photo of my settings for you to try shortly… see below link.

These are my settings for the curves.

Might give you a place to start.