RWR and CMDS DEGRADED message on cold start
-
Hi all
what should be the exact order to swich on systems to avoid the DEGR message for RWR and CMDS on start test when doing a cold start?
I know that not suposes a real malfunction, but I would like to avoid to reset warnings page on MFD
-
Go to the test page. Clear the list. Read the checklist, you’re supposed to to that.
-
Ty,
but what I want to avoid is that messages in test page
I you follow checklist avionics those messages apear always
I know its not malfunction and reseting warnings leaves all system ok but
there is not an sequence or timing to swich on avionics so system doesn’t report that start error messages?
-
Ty,
but what I want to avoid is that messages in test page
I you follow checklist avionics those messages apear always
I know its not malfunction and reseting warnings leaves all system ok but
there is not an sequence or timing to swich on avionics so system doesn’t report that start error messages?
Read the manual. It says that you should clear the maintenance fault list (make sure you pusher FLCS reset beforehand) when doing a ramp start.
-
Yeah I always reset and clear FLCS fault
but I though that a certain sequence and timing should avoid RWR and CMDS start warnings
-
…yes… if you power up rwr and cmds FIRST , before everything… not possible? … and imho - why??? - just clear the damn list - now … if it shows later again, (few secs) after clearing the list … then you’re in world of hurt