Falcon BMS 4.37.0 - Documentation: Bug reports
-
Document: BMS-Training.pdf
Page: 109
Original sentence: he engine …
Corrected sentence: The engine: … -
BMS Training Manual 4.37
page 40
original: “If not, as in this example the diamond is displayed with an X through it at the edge of the HUD…”
corrected:" If not, unlike in this example, the diamond is displayed …" (rationale: the screenshot shows the diamond, not the X)page 307 (SA-6 section)
original: “NOTE: …that the SA-11 is highly mobile.”
corrected: “NOTE: …that the SA-6 is highly mobile.” -
Threat guide
page3-
Ac = aircraft, or should it be in abbreviations list.
-
At the bottom, the text is fading
-
-
Hi!
Parking place numbers are misslabeled in the charts. I tested only at Seosan, but I think other ABs affected too. First picture from a rampstart. Second picture is after arrival. Ground control told me " Delta 03". I went on the red line, stops at yellow and watched where my wingman goes. The other two F-16 were parked already, so after my wingman stopped, it was clear where is my place.
-
@hiuuz Have you read this post?
https://forum.falcon-bms.com/post/360901
Does that match your observation?Cheers
-
@Wolfman Oh! I thought the game is OK (starting the sequence of parking numbers with zero seems strange to me), so I came straight here to “Documentation: Bug reports”. Didn’t see your post!
-
Document: -1
Page: N/A (entire section was removed during reorganization)
Original sentence: N/A, entire AP switch/functionality was removed from the -1 in 4.37.
Corrected sentence: autopilot switch functionality section added back into the -1.Thank you for your support!
-
Train Mission 6 ILS Bad Weather
The training manual refers to this variant:
The variant in the mission is a Block 52 which does not have the mode knob listed in the training manual.
-
Unless I’m doing something wrong, I find the 4.37 documentation is inconsistent with the functionality of the ECM power switch. The documentation is likely right, but the switch appears to be modeled incorrectly. It behaves as a two-way switch, not three-way. Refer to Training Mission 1 (Ground Ops), the switch can’t be put into the middle position (STBY).
Document: TO BMS 1F-16CM/AM-34-1-1
Page: 128, section 2.8.2, item 1
Original sentence: “Power switch (3 positions) - OFF, Standby (STBY), Operate (OPR)”Document: BMS Training Manual
Page: 22, first paragraph
Original sentence: “4. Check the ECM panel and toggle the top left switch to STBY.”GC
-
Thanks to all reports. If possible and relevant, all is fixed.
-
-