FSSB R2 Force recalibrates
-
I have found, through foxy app, that the force required will change if the force used exceeds the app’s range.
In essence, if i use enough force to exceed the range, a re-calibration takes place, whereby more force is required for the same amount of deflection the next time i use that axis.
In a dogfight scenario, this can be frustrating, as more and more force is required, and its easy to lose consistency.
Has anybody else experienced this?
I am thinking of placing deadzones at the end of x and y axis, using the HOTAS control panel and seeing what happens
Any pointers would be appreciated.:drink:
-
Are you using manual cal or auto?
-
-
You should use manual cal, that is your problem.
-
force sensors should never use auto cal
So indeed use manual calibration -
thank you
will try manual calibration.
-
@Red:
force sensors should never use auto cal
So indeed use manual calibrationAin’t that the truth… I ended up snapping the neck of my stick by it re-calibrating each time and getting harder and harder to pull. lol
-
Ain’t that the truth… I ended up snapping the neck of my stick by it re-calibrating each time and getting harder and harder to pull. lol
was doing that myself……was learning how to not overstress, to incur the recalibration…