BMS 4.34 screenshots
-
@tad:
Displaying shots of your F18 pit with DCS textures is ALREADY copyright violation. Very disappointing!
I’m not an expert on copyright. As long as I don’t share it with anyone, I don’t believe it’s copyright infringement. Because I just use it myself. But when I think about it again, at least it’s not ethical. Maybe it would be better not to share the cockpit screenshots. Thanks for reminding.
-
But when I think about it again, at least it’s not ethical. Maybe it would be better not to share the cockpit screenshots. Thanks for reminding.
And thank you for a quick response and understanding. This forum represents BMS’s good name and all is done for BMS. I am sure that your cockpit can have even better textures.
-
Some picture with different angels. All but the rear pit of the B-model were shot in free cam mode.
Back seat view
The stunning amount of detail
Looking at the camera guy
-
@NIL:
Some picture with different angels. All but the rear pit of the B-model were shot in free cam mode.
Back seat view
https://i.imgur.com/s7sbVgG.pngThe stunning amount of detail
https://i.imgur.com/t6dUWwe.pngLooking at the camera guy
https://i.imgur.com/AcRfomY.pngWOW! Is that a mod?
-
The back seat view? If yes, then no, it’s my topgun view for this model…
-
@NIL:
The back seat view? If yes, then no, it’s my topgun view for this model…
I wish to have a fully implemented backseat F-16 !!!
-
-
-
-
@NIL:
The back seat view? If yes, then no, it’s my topgun view for this model…
I thought it`s functional backseat. Beautiful anyway
-
@f4.0:
Its the Janhas model
Yes…
-
AS.30 rocket flame(s) may need some lod trick and fm edit to reproduce two-stage rocket motors. it also needs a flare at the end of missile for visual guidance…and the flare better be super bright and getting bigger at far distance.
https://en.wikipedia.org/wiki/AS-30
The AS-30 has a two-stage solid-fuel rocket motor. A short-burn-time booster section exhausts through two large nozzles located midway between the rear edges of the missile’s large fins, after which a longer-burn-time sustainer ignites, and exhausts through a nozzle located at the center of the back of the missile body. As with the AS-20, the AS-30 uses a simple MCLOS guidance with the pilot aligning the flares located near the missile’s rear with the target and controlling the missile in flight after launch with a small joystick, sending steering commands to the missile via a radio link. The steering commands steer the missile back to the line-of-sight by thrust vectoring, by the movement of one of four metal vanes around the sustainer nozzle. The missile’s internal gyro gives the missile command unit the correct position of the missile in flight, so each of the four thrust vanes can actuate at the correct time to steer the missile back to the correct flight path.
-
AS.30 rocket flame(s) may need some lod trick and fm edit to reproduce two-stage rocket motors. it also needs a flare at the end of missile for visual guidance…and the flare better be super bright and getting bigger at far distance.
Honestly, I think it’s not that bad…
-
Honestly, I think it’s not that bad…
Don’t get me wrong, your model is great.
my point is, your model shows two flames from launch motors, both only last for 2 seconds. A sustain motor at the end of missile ignites 1 second after launch. you may need Xswitch nodes for flames and fm edit to reproduce the feature. Or simply ignore it as the missile fired away.
https://en.missilery.info/missile/as30l
The AS-30L rocket is made according to the normal aerodynamic scheme, has solid propellant marching and launch engines. The launch engine is inseparable and is equipped with two nozzle blocks. Two nozzles of the launch engine have a small angle of half-solution and are located outside the rocket body in special recesses of the tail compartment on both sides of the nozzle of the marching engine. The run time of the launch engine is -2s, it provides the rocket speed relative to the carrier up to 200m/s. The marching engine is launched in 1 s after the launch of the launch engine and accelerates the rocket to a speed of about 450m/s. Nozzle of the marching engine is in the center and is connected to the combustion chamber of the marching engine with gas, laid on the axis of the rocket. The marching engine is equipped with a traction vector control system consisting of four gas-dynamic rudders - deflectors with electromagnetic drive. Control is combined and carried out as aerodynamic surfaces, and gas-dynamic rudders.
The other point is, it may need a Xswitch flare marker for visual guidance… if it’s set as a man-in-the-loop weapon, like AGM-12/AS-7.
-
2020-11-23_024001 by Flight Fence In, su Flickr
2020-11-23_024145 by Flight Fence In, su Flickr
2020-11-23_023738 by Flight Fence In, su Flickr
“AD HOSTES RUGENS”
it’s getting serious
Cheers
-
Quick flight test……
-
HO HO HO!
-
@luke777, wow nice. Always wanted that skin for the default model… Looks good…
-
Skin needs final touches
-
Very nice luke777. Looking forward to see what you come up with next…