Cougar Buttons assginment mix up
-
Did you try recalibrating?
-
@Icarus Yes, with and without throttle to check if the diods is damage in first test. I open the throttle and the board have in diods vermilion, i clean and check if works. Yes all diods is work correctly.
after the buttons of stick have the same problem, i believe is some component in board. If somewhere have the same problem and give a north to i fix this problem.
Thanks
-
@Anvil did you find any boards to change? I have the same problem as you
-
@gusva something I vaguely remember from long ago, I don’t remember if it was stick, throttle or both but, one of the male connectors on the circuit board has 2 extra header pins than the female connector and if not paying close attention you may connect incorrectly causing lots of button malfunctions.
Of course it wouldn’t make the buttons stick but, just putting this out there, in case. -
@Badger Where in board? You remember, the stick connector? the potentiometer connector? if give me a cue i thankful.
-
@gusva Did you calibrate multiple times. It took me three or four tries to get my buddys Cougar calibrated. Buttons mixed up in ccp sounds also like a short or neurtal wire issue.
-
@Icarus i will replace my sensor hal to pot again to try isolate the problem, perhaps is the short or neutral issue. i return here with a reply soon.
-
@gusva Sometimes a wire gets pinched when you put it back together
-
@Icarus Exactly what you said happened, it was a short circuit when closing the Stick. I changed the wire from button 5 to a new one, and did a test by placing the open sitck on the base. The problem was gone. So it was the insulation of the contacts that shorted out when closing the stick, I isolated all the contacts again and the problem was solved,
-