Hey Red Dog
-
First excellent job on manuals, found a oddity in F 16 CM -34-1-1 page 25 following the word “important” line indicating TMS up to set a markpoint as opposed to F 16 CM 34-1-1 page 110 Line 7 Starting with “STPT at the exact location…” “enter” to set a markpoint ?
Weaklink
-
There are so many different blocks and tapes around…
MLU M3 manual describes the version implemented in BMS IIRC
-
Didn’t see a Dash 34 specific thread yet.
My first bit of feedback:
Page 196 and 197 state that the Impact option and spacing settings are only available for JSOW and WCMD. They are however also possible for SDBs (and working).
The fact that it only works with two racks is however incorrect (should be possible to use off just 1 BRU-61) but that is not a documentation issue but a sim implementation issue
-
Dear all,
I found a typo in dash 34.p112, line 19 ; The position of slant rage, time-to-go and distance/stpt# markings were adjusted.
slant rage –> slant rangeIf I find more, i will report.
Thanks, -
p112
Part of the text from the old 4.32 manual. Corrected for next version, thank you.
-
More things I found in Dash34
p200 line13: 5. 5. JIZ -> 5. JIZ
p202 line11: optimal release zone (RMAX1 to RMIN1) -> optimal release zone (RMAX2 to RMIN2)
p210 line3: cability -> capabilityThanks,