So I made a very good (for me) profile for my new warthog. It’s a mesh of a TARGET profile for the throttle (so I can use all the buttons) and the normal DX mappings I did directly in the falcon UI for the stick.
I’m only stuck with the idle detent part.
The throttle has no axis response past the idle detent, but it acts as a DX button. For now I set the DX detent correctly, and I can hear it “clicking” when I move the Warthog throttle past the detent, but the engine doesn’t start.
Any ideas on how to set it up so it works properly? Where should I set the idle detent in the UI?Thanks
Here is the post where I described the how/why of the idle detent using the TARGET software: