Thanks for the reply Goblin.
After a bit of work/trial and error I managed to get my setup working.
I used the DuncDX_replacement Foxy files from the BMS 4.33 Cougar files (in the BMS directory) and modified the BMS_Full.key.
Tips for young players:
1. In the Controllers screen in BMS select the Warthog stick as the primary controller
2. Select the BMS_Full.key file and then systematically go through the ‘stick’ part of the file and re-map all the DX buttons on the warthog stick (then click ‘save as’ and rename the file!)
3. Set up the axis as required in the Avionics tab
4. (AND THIS IS THE IMPORTANT ONE) leave Foxy and CCP OPEN when running BMS!!!
So before I launch BMS I now run through a mini pre-flight checklist where I launch TrackIR, Foxy and CCP. I download the profile to my Cougar setup using Foxy and also use the Viewer in CCP to verify that all my axis are responding (especially the mouse cursor).
Once that all checks out I launch BMS.
I’m just writing all this in case it might be of use to others in the future.
Check six!
🙂
RBG