Do you have “Use High Res Textures” box checked off in the config setup? This may help but not sure for cockpit.
Latest posts made by Pooky
-
RE: Cockpit Resolution Issues
-
RE: Dunc Laser Pointer on TG1 not firing
Is your laser set to “combat” and not “trn”? Do you see an “L” in the TGP?. I also use DuncDX and it works OK.
-
RE: Cougar TQS Parts
Super Glue did the job. I used the Future Glue gel. Can’t see the repair.
Thanks to all for suggestions. I tried TM site but couldn’t get on. I have ordered parts from them in the past but their new web site is impossible to connect with “contact us”. -
RE: Cougar TQS Parts
This is a brand new TQS, never been used. Might try some super glue.
-
Cougar TQS Parts
My Cougar TQS is broken at the three mounting screws where the handle with all the switches attaches to the throttle arm. This is an all plastic piece. The bracket has snapped in half. Looking for a replacement.
-
RE: Display Both Engines rpm on F 18 C
There is a way. Unfortunately I don’t recall the command/setting.
I’m guessing it’s in Falcon BMS config because I only had to do it once.
Check Falcon BMS cfg file under DEV section. Mine is set to 1. This may relate to the HUD though.
-
RE: IKAROS Theater v4.1.0
Great looking theater. Many thanks to all for your hard work.