G13 profile
-
I just program the G keys (using the Logitech software) with the key combos found in the controller setup in the UI.
Then, using a label machine, made labels for the keys and pasted them on the G13 keyboard.
Here’s a look at mine…
-
Exactly what i needed! Perfect, thanks!
-
Similar to what I did, but I don’t have that nice of a label maker so I couldn’t do white on black. Mine is only used as ICP/DED, originally I was going to use the othe modes but never really got around to it because I had limited label space and definitely wouldn’t remember the other modes without it. There are some diagrams of the G13 you can fill in though if you want to post them up next to it or something.
You can chop off the wrist rest if you are handy with a Dremel. It was blocking too much of my center instruments monitor.
-
Guys,
I am finding that when I input my keystrokes into the g13 it is adding a shift modifier on keys on the numpad when activated in the UI. Any ideas or thoughts? Hope it has nothing to do with device arrangement.
Thank you in advance,
Vags
-
NUMLOCK was the culprit.
Thank you,
Vags
-
Make sure number lock is back on in 3D.
-
Thank you for the heads up,
Vags
-
when I used a G13 I set mode 2 to be used for AI comms.
Note the top row of buttons is the same amount of the comms menu (COM1: Q; COM2: W, IFF: E, LIST: R, A-A: T, A-G: Y). No need to remember that, it’s just QUERTY from your keyboard behind it. And then set the ICP numbers to act as the normal numbers on your keyboard.
So requesting fuel would be Y + 1, or on G13 labeled with ICP buttons A-G + 1 T-ILS. -
Thank you for the input, always welcome.
Vags
-
The G13 is a good bit of kit for anyone wanting to setup an ICP [emoji41]