About Update 2
-
Nothing… Still the same fps
-
Strange… I recall someone else also complained about the FPS drop with the latest update… I have a pretty weak vid card, a Radeon HD series 65xx, and I’m lucky if I get 35 fps in the cockpit, but, oddly enough, nothing has changed since I installed U2. What gives?
-
I have a weak graphics card too, i have a GT630 NVIDIA, but before U2 falcon runs at more fps…
-
Is your vsync off?
Sent from TapaTalk
-
Take a look here, may be your solution: https://www.benchmarksims.org/forum/showthread.php?28577-4-33-2-with-decreased-FPS-in-cockpit
-
I agree,
with my gtx 970, it seems u1 has better fps compared to u2 too. -
Should Update 2 delete my running campaign, and my actual setup configuration ?
Thanks -
Yes, it’s off
-
Same here. VSync always off, HDR too. AA and AF set on the BMS graphics configuration page, in the vid card software left ‘application dependent’.
-
Definitely u2 lost optimization
-
If I might suggest something, try Tom’s cockpit textures (backup the stock set first). I may be totally wrong, but I have an impression that they are somewhat lighter in terms of gfx load…
-
This may be a shot in the dark, but apparently U2 resets F4Patch settings to default. For this reason, one should go into the Config applet and set everything back the way it was before Falcon is started. Good luck :).
-
This may be a shot in the dark, but apparently U2 resets F4Patch settings to default. For this reason, one should go into the Config applet and set everything back the way it was before Falcon is started. Good luck :).
Please read : https://www.benchmarksims.org/forum/showthread.php?28573-Falcon-BMS-4-33-U2-Incremental-Installer
-
This may be a shot in the dark, but apparently U2 resets F4Patch settings to default. For this reason, one should go into the Config applet and set everything back the way it was before Falcon is started. Good luck :).
That’s odd, Tancred– I just checked, and U2 didn’t reset my F4Patch settings to default. In fact, it didn’t make any kind of changes at all to my config file.
-
Guys, if you’re using a 60Hz screen, why do you want more than 60FPS? I loathe screen tearing. Also, if your FPS is constantly rocketing up to 100FPS and plummeting down later you’re going to get stuttering. I’d much rather cap the FPS at 60 and have less extreme differences in FPS and with zero tearing.
-
Whoops, I thought that what was written in relation to the settings accessible through Falcon’s UI. The change was perceived on my Linux install, it could easily be that I’m wrong with regard to Windows.
-
Tancred…. Did you read my post? I APPLIED ALL MY SETTINGS AGAIN… AGAIN… Do you understand the point?
-
Im having no FPS issues at all…. runs smooth as silk
-
Just gave it a spin in a TE didn’t notice anything changed or altered in a negative way like fps drop or problematic performance. Smooth…
-
I also have performance problems now. GTX 1080 and i7 4770K, 16GB ram. With vsync, it looks really choppy and bad. Used to look smooth as silk. Without, it tears like crazy. Tried tons of different settings, updated drivers, tried nvidia inspector, tried 2 other people’s bms and nvidia control panel settings, nothing. Even if i lower all graphics, still looks choppy with vsync even though frame rates are locked at 60 and never drop. Without vsync, i get 100-115 fps no matter what.