Has anyone bought and tested the TM TQS?
-
Thanks.
And I’m sure I’ll llove it too.
But the 50% isn’t linked to the light points, which I’m probably not going to use. You underestimate the power of TARGET and what it can do.
If I were content with the DX assignment, then yes it should be operational.
Regards.
-
@Echo said in Has anyone bought and tested the TM TQS?:
Pitch ALT HOLD / A/P / ATT HOLD
That switch has been like that for years. Wonder why they never fix it.
-
@Tradio How did you get yours to show up? Is it the TWCS Throttle?
-
Just a reminder, you’ll need to tell BMS that you’re using a device with more than 32 buttons on it by adding an entry into your Falcon BMS User.cfg, such as
set g_nButtonsPerDevice 64
Then your stick will use DX0 to DX63, the Viper TQS will use DX64 to DX127, (depending on your device sorting in the DeviceSorting.txt.
After 20+ years, my Cougar is totally worn out. I can finally use the Warthog stick and Viper TQS throttle combo
-
@MailMan - no - the TWCS Throttle is an attempt at a Hornet Throttle:
https://www.thrustmaster.com/en-us/products/twcs-throttle/
…and not a very good one, really.
-
Here we are. A new version of T.A.R.G.E.T has been released.
-
-
@Rouge1512 - Coolness!
-
@Echo me either
-
Okay when i klick on “New Configuration” the “Viper BBox” is shown but "Disconnected
Case opend at TM Support
-
@Echo I have the same problem. The firmware is up to date as far as I can see. Not too fussed at the moment as I stopped using TARGET many, many years ago. But it might be necessary to control the lights.
-
If you have the Viper TQS Mission pack and if you click on “F16 viper TQS” then, further on in TARGET, in the programming pages, you will have access to both the throttle and the BBox
-
But shouldn be it “connected” ?
-
@Echo
It is through the “F16 viper TQS”, since the two form a single unit. But it’s true that the picture doesn’t tell the whole story.
“F16C viper Bbox” is for those who only own the BBOX, without the TQS. -
My question is how do we get the lights to come on?
-
@MailMan
I couldn’t…
TM just pended my question about failure in supporting TARGET.
I am just playing my TQS by setting the AXIS, KEY in BMS game. -
@Tradio I have never really used Target before. Looks like more trouble than what it worth. Alt Launcher Keymapping is so easy. I just wanted to see if I could get the indicator lights to work with Target. I do know if you run a Target Profile, anything you have programmed in Alt Launcher gets over road. So until they come out with firmware that supports BMS, I guess we are out of luck. Maybe if the get bogged down with messages, they will get on the ball
-
Your are correct, and exactly what support wrote to me.
The software only shows connected if ONLY the panel is connected.
And they gonna make it better in later releasesSo you can address both in the T.A.R.G.E.T when you create a profile, where the additional axis is also added from the panel
In the Picture you can see all TQS axie + the panle axie
-
Just got this from Thrustmaster support:
supportTM [email protected]
8:35 AM (40 minutes ago)
to meHello James
We thank you for contacting Thrustmaster Technical Support.
We can confirm you that this week a new version of T.A.R.G.E.T. came out, where the TQS will find his full functionality.
Unfortunately at the moment we are still working on a manual regarding the LED’s, but to confirm to you already that these LED’s are present in the device and normally will work in the near future.Thank you for your patience,
We wish you a nice day and remain at your disposal for any further questions.Best regards,
Bruce, your Thrustmaster agent. -
@ViperDriver
Good news - Thanks.