Skinning
-
@Icarus Thanks but i don’t want the IAF cockpit seat. I don’t plan on flying the IAF F16’s. I just want to customise the cockpit seat for standard USAF/ROK F16’s.
-
@Rich_EXF Well mine are working. I checked and yes 811.dds is the correct one for F16. Not sure what you are doing wrong. How are you converting your artwork to dds files? I use DXT5 interpolated alpha.
-
@Icarus I’m not sure why it refuses to work either. What I’ve been doing is copying the orginal 8011 so I can work on it. I open it in paint.net. All I have been doing is adding some text artwork to the seat with a name /callsign on it. I then save it. As per a post I found from I-Hawk I have been saving it as DXT-1 with MIP mapping. I then remove the original from the Korea objects folder and drop in my modded 8011 into the folder. I have even done this for the hi-res folder too. Neither works. I have even used an old modded 8011 supplied by one of my old VFW’s (so I know that file is good), dropped that into Korea objects and still all I get is the same basic blank cockpit seat. I don’t understand why?
-
@Rich_EXF I cut and replace contents of high res folder into my koreaobj folder then turn off high res in configuration and then put in my files. It sounds like it is defaulting to the low res or something. Try that. Back up first.
-
Hello,
if you want to add something on your seat you should edit the 8036.dds file
if you want something like this:
in this position on dds file:
saved in dxt1 no aplha with mipmaps
Best Regards
-
@dema Thanks Dema, I forgot about that one. Its been a while since I messed with the seat.
-
-
@dema Yes I just checked. 8036 is for USAF-16. 8011 is for ROKAF-16 . 8032 is IAF-16 I think.
-
Yes thanks both. I finally got it working. 8036.dds was the one i needed to edit. Thank you so much.
-
@dema do you have the paintkits for janhas f16s?
-
@okayasugf said in Skinning:
@dema do you have the paintkits for janhas f16s?
I have got the tail psd