Here is a nice 3d printed HAL sensor
-
My upgrade kit arrived recently - looking forward to installing it, I’m confident it will work well. I’m holding off for a while, though, to see how long my utterly crude fix to the throttle pot lasts.
My throttle pot (and the stiction in my TQS) isn’t nearly good enough for something like aerial refueling, I’m sure… but I’m not good enough, either! Nowhere near. So, I’m going to keep using my crudely repaired throttle pot for a while, just out of curiosity about its lifetime, while I s-l-o-w-l-y work through the basic training modules. Then I’ll work on the stiction some way or another, and then put in this sweet sweet Hall sensor from Redneck. Thanks heaps for making this!
-
Arrived (throttle) and easily mounted. Fully working.
Thanks mate! -
how much is the throttle only?
-
-
Great to see people satisfied with this mod! I can finally look back at the endless days i spent cursing at thrustmaster with a smile on my face!
-
Easy install. Works perfect!!
-
Now we need a microstick replacement….
-
Now we need a microstick replacement….
A slippery, non wearing (or cheap to replace) gimbal might be more achievable.
-
Maybe better fixed gimbals for pressure sensors like the pistolero mod.
Στάλθηκε από το MI 5 μου χρησιμοποιώντας Tapatalk
-
can you make it for old plastic FLCS/TQS? I modified the PCB and wires for USB.Just I need it to replace the pots on HAL.
-
Well i dont know the internals of that particular stick.
And designing for just one is awfull lot of work. -
Bumping so anyone with damaged pots can see this at the top. Maybe make it a sticky?
-
@Master:
Bumping so anyone with damaged pots can see this at the top. Maybe make it a sticky?
Bumping again for the above reasons