CCP has dead zones and axis shaping so not issue for the “make more/less sensitive” Its not intrusive being only to initially setup the cougars firmware then closed. I do not see the conflict.

As a long time Cougar user I can only say I have never had the issue OP refers to,

The Veterans-Gaming server ran 3D fine in a 1024 window on the desktop until very recently. Although the loss coincided with the U2 update i think that is just coincidence and possibly some recent win10 update has changed something. I can`t see what else could have.

A Torch/Flashlight would be ideal to simulate RL. I wrongly thought BMS used to have it.

Do you have any numbers for 1280x1024 please ? Though i guess probably will not work when the issue is only having 1920 as adaptor option for some unknown reason.

Resolution for 3D window. There are no options except for 1920. This is a new situation but as i wrote not U2 related. I suspect its PC related rather than bms but out of ideas.

That was dumb. Its dx11 now. Ok so deleting dx11 dsp did not help. The issue is no resolutions available in setup option for 3D other than 1920x1080. Was ok before but now the situation even with a 4.35 U1 fresh installation.

I have no advice but I am very pleased with my change of base to the WarBrd for my Cougar.

@JoseyWales:

I still have v4.33 and Falcon 4 that I bought off of Steam. I am having so much trouble. The typical message window telling me I don’t have Falcon installed. I’ve googled until my eyes went blind.

Is there some trick to loading BMS if one has a steam version of F4?

So wanting to get back into Falcon…I had it perfect on my old system, but alas it died. This new system runs Windows 8.1, 24Gb ram, 2 TB drive…GTX-1060 w/6Gb

Please send Help!

Can you run/play the original Falcon 4.0 ? If yes then it is installed. As Airtex2190 wrote, plenty of players using the steam F4 installation.

Ok well hopefully you clicked apply after any changes you made. I strongly suspect you have a very simple issue. Good luck with it.

PS be sure to use the supplied viewer to quickly see what axis is moving and with what assignment.

edit to earlier post [[COLOR=#333333] When you run the CCP there should now be red X ON A GREY BACKGROUND ]