Cycling radio presets.
-
In 4.33 I could go ICP > COM 1 > type my frequencies into the DED scratch pad press enter and good to go.
If I go to COM1 now in 4 34 and change the ‘preset’ # using the ICP and press enter it doesn’t change to the preset entered.
It seems I have to be on the DED default page and use the rocker switch on the ICP to change radio frequencies.
I ignored this for a few months but it has become some what of a annoyance.
-
I find using the rocker switch easiest especially with how the new ATC systems work. You should only be going up or down one frequency at a time. I bound the rocker switch to my HOTAS for ease of use.
-
nothing has changed in respect to ICP or DED in radio regards between 4.33 and .34 therefore it must be an issue you are doing… procedure still the same… enter com 1 or 2 type in either a freq or preset number desired then enter
-
How are you typing them in? Numpad? If so, have you tried clicking the ICP buttons and does it yield the same result?
-
nothing has changed in respect to ICP or DED in radio regards between 4.33 and .34
Confirmed.
-
How are you typing them in? Numpad? If so, have you tried clicking the ICP buttons and does it yield the same result?
As a matter of fact, I was using ICP buttons. I was doing it by clicking them with the mouse, I don’t have a physical device nor an external app for that.
-
As a matter of fact, I was using ICP buttons. I was doing it by clicking them with the mouse, I don’t have a physical device nor an external app for that.
Are you getting the same problem as quicksilver?
-
I’m not. Also, it seems that I forgot to hit post on my previous message stating that.
-
Sorry guys it was a silly mistake on my part. I wasnt typing the preset number between the asterisk on the COM1 page I thought that was for 5 digit frequencies. I was scrolling over the current preset on that page and when pressing enter and switching back to the default page it ignored the change. works flawlesss.