[4.37] IFF codes not loading at RAMP startup
-
Before mission start i press IFF PLAN button in the DTC then save.
After i do all the ramp start procedures and take-off the IFF is working fine using TMS left.
In the FCR i see all the IFF 4,2,1 marks.When i press IFF button below the hud it shows the page with no codes :
Is there something else i need to do at pre-mission or RAMP phase to see the codes from the briefing page ?
-
@regev
Just for confirmation…
CNI is switched to UFC, right? -
@Amadeus75 said in [4.37] IFF codes not loading at RAMP startup:
@regev
Just for confirmation…
CNI is switched to UFC, right?right
-
@regev said in [4.37] IFF codes not loading at RAMP startup:
Before mission start i press IFF PLAN button in the DTC then save.
After i do all the ramp start procedures and take-off the IFF is working fine using TMS left.
In the FCR i see all the IFF 4,2,1 marks.When i press IFF button below the hud it shows the page with no codes :
Is there something else i need to do at pre-mission or RAMP phase to see the codes from the briefing page ?
DTC loaded in 3D?
-
@regev
This may not be your issue, but are you coupling the SCAN/LOS interrogator during ramp start or airborne? Reference this post: https://forum.falcon-bms.com/topic/23825/allied-aircraft-do-not-respond-to-iff-interrogation/8 -
@LorikEolmin said in [4.37] IFF codes not loading at RAMP startup:
DTC loaded in 3D?
How can i do this ?
-
@Gunz_ProSkies said in [4.37] IFF codes not loading at RAMP startup:
@regev
This may not be your issue, but are you coupling the SCAN/LOS interrogator during ramp start or airborne? Reference this post: https://forum.falcon-bms.com/topic/23825/allied-aircraft-do-not-respond-to-iff-interrogation/8Not being aware of this one . . .
I will check it, thanks. -
@regev
As @LorikEolmin also inquired, if you are not loading the DTC in the 3D cockpit its all a mute point. After saving the DTC in the BMS UI, you also need to load the DTC using the DTE OSB.The DTC is inserted into the DTU (Data Transfer Unit) and loaded through the DTE MFD page with the LOAD button. Each label on the DTE page will highlight briefly as the corresponding settings are loaded into the jet.
Reference “5. Data Transfer Cartridge” in the BMS User Manual. Hope that helps.
-
@Gunz_ProSkies said in [4.37] IFF codes not loading at RAMP startup:
@regev
As @LorikEolmin also inquired, if you are not loading the DTC in the 3D cockpit its all a mute point. After saving the DTC in the BMS UI, you also need to load the DTC using the DTE OSB.The DTC is inserted into the DTU (Data Transfer Unit) and loaded through the DTE MFD page with the LOAD button. Each label on the DTE page will highlight briefly as the corresponding settings are loaded into the jet.
Reference “5. Data Transfer Cartridge” in the BMS User Manual. Hope that helps.
Very good info, i think it might be what i am looking for. Thank you very much