Has anyone bought and tested the TM TQS?
-
@Echo said in Has anyone bought and tested the TM TQS?:
And don’t be supriesed the switch from “Pitch ALT HOLD / A/P / ATT HOLD” is not movin in 3D, at least when i tested it in the GroundOPs TE
May F-16 avionics does not allow AP settings on the ground because of safety reasons You don’t really want to try to take off with AP working
-
@huffer2
Viper TQS is connected and functional.
But I can’t find that in T.A.R.G.E.T to program some script。
Is there anyone who was successful at the TARGET script with Viper TQS.
-
We have to wait ( 3 or 4 weeks ? ) a new version of TARGET.
A bad joke from TH : they release a beautiful car without any steering wheel.
And we are enought stupid to buy it. -
You do not need TARGET in order to make full use of the TQS and panel. (backlighting maybe aside)
Just in case others didn’t know that.
Regards,
Gary
-
Thank you for your input.
Yes, I know but at 50% of its capacity .
I want the steering wheel because I use to drive like this and I need 100%.At the moment, the “car” is waiting in its box, thing I don’t find funny.
-
-
I’m not sure a couple of LED’s not working is representative of 50% functionality. Personally I would say its already 90% functioning as intended but we all make our own judgements and have our own priorities of course.
I’m sure you will love it when the software finally comes and you can use it to its full potential though.
Regards,
Gary
-
Thanks.
And I’m sure I’ll llove it too.
But the 50% isn’t linked to the light points, which I’m probably not going to use. You underestimate the power of TARGET and what it can do.
If I were content with the DX assignment, then yes it should be operational.
Regards.
-
@Echo said in Has anyone bought and tested the TM TQS?:
Pitch ALT HOLD / A/P / ATT HOLD
That switch has been like that for years. Wonder why they never fix it.
-
@Tradio How did you get yours to show up? Is it the TWCS Throttle?
-
Just a reminder, you’ll need to tell BMS that you’re using a device with more than 32 buttons on it by adding an entry into your Falcon BMS User.cfg, such as
set g_nButtonsPerDevice 64
Then your stick will use DX0 to DX63, the Viper TQS will use DX64 to DX127, (depending on your device sorting in the DeviceSorting.txt.
After 20+ years, my Cougar is totally worn out. I can finally use the Warthog stick and Viper TQS throttle combo
-
@MailMan - no - the TWCS Throttle is an attempt at a Hornet Throttle:
https://www.thrustmaster.com/en-us/products/twcs-throttle/
…and not a very good one, really.
-
Here we are. A new version of T.A.R.G.E.T has been released.
-
-
@Rouge1512 - Coolness!
-
@Echo me either
-
Okay when i klick on “New Configuration” the “Viper BBox” is shown but "Disconnected
Case opend at TM Support
-
@Echo I have the same problem. The firmware is up to date as far as I can see. Not too fussed at the moment as I stopped using TARGET many, many years ago. But it might be necessary to control the lights.
-
If you have the Viper TQS Mission pack and if you click on “F16 viper TQS” then, further on in TARGET, in the programming pages, you will have access to both the throttle and the BBox
-
But shouldn be it “connected” ?