@ericfa2a said in How do you deal a fight against a J-20 in a f16 ?:

If we take Top Gun Maverick as reference, it’s true that there are some mistakes in BMS database :).

That is on point!

@Icer said in How to remove J-20 from the campaign:

@nuNce said in How to remove J-20 from the campaign:

Hello, I’ve recently noticed that the J-20 has appeared in my KTO Rolling Tiger campaign. I tried removing it with Mission Commander by changing my savegame, but without any luck unfortunately.
f6a254a-6e2a-4ae3-bbae-540132bc3e17-immagine.png](https://i.imgur.com/j6erWMq.png)
Is there a way to remove the J-20 without restarting the whole operation?
Personally it’s not a welcome addition as it disrupts the normal flow of campaigns in a frustrating manner. Thank you.

Where did you find a KTO Rolling Tiger campaign? I only have Tiger Spirit and Rolling Fire…?

Obviously I made up a new campaign title. 🙂
It’s Rolling Fire.

Why putting your PC at risk by installing an OS that is no more supported?

Win10 work as good or even better on old hardware…

When I tell my wingman to “weapons hold” ( by pressing W6) he says “On my way” and something else I can’t get. Doesn’t seem to be the right response. What am I missing?

Hi, I’ve an Winwing Orion stick and throttle. Even though I’ve done all the steps in the tech manual to stop axes being reassigned at start up (then made devicesorting.txt,joystick.cal. etc read only), when i start bms my ‘joystick’ (ie elevator/aileron control) does not respond. When I map the stick again it then forgets everything it had mapped for throttle, and I need to remap the whole thing again. DX buttons are still recognised.

I am using 128 button config (in user config file)
Virtual rudder in use

I don’t know if the following is relevant:

For some reason, bms always ‘highlights’ my throttle in controllers section, even though it is the second device on my list. The throttle mappings are persistent between bms starts, but my stick settings always get ‘lost’ (ie no joystick input recognised - DX buttons work ok though).

When I look at the axismapping.dat, the winwing devices are listed, but there doesn’t seem to be anything mapped against them?

When I go into controllers, it defaults to a key file name I deleted a while ago? Not sure what is happening there.

Do I need to ‘force’ axes in axismapping.dat by manual edit then make read-only?

How can I stop it defaulting to old key file (I have deleted that file too in config to try to fix it)?

Grateful for any advice. It is starting to make me lose my mind!